murat писал(а):Р 2800 и Р 0700
P0700 is the code which notifies drivers of the occurrence of TCM related problem indirectly as illuminating engine check lamp. If this code is recorded, Do not check engine but auto transaxle.
ECM and TCM give and take various data through CAN communication each other. When the problem of TCM related sensor(input speed sensor, output speed sensor, inhibiter switch, etc.) and actuators(transaxle solenoid valve, etc.) occurs, gear is fixed at 3rd gear position. However, there is no alarming device such as "TCM warning lamp" which notifies drivers of the occurrence of TCM related problem.
Therefore if power train related problem happens, Engine check lamp turns ON to let drivers recognize the occurrence of power train system(A/T system) related problem.
P2800 Transmission Range Sensor "B" Circuit (PRNDL Input)
Эти ошибки - следствие исчезновения "резвости". Если по системе управления двигателем других ошибок действительно нет, начать надо с простого - замены воздушного и топливного фильтра, проверки подсоса воздуха в топливную систему и т.д.